Chimney Company in Long Beach — Flat-Price Sweep, Photo Report Included

A flat-price sweep with a camera inspection and photo report included. If we find something that needs attention, you see the picture before you hear a price — and we will tell you when it can wait.

✓ Licensed & Insured ✓ Written quotes ✓ Permits handled
Book My Appointment

Flat price quoted before we book

🛡 Licensed & Insured 📝 Written Fixed-Price Quotes 💲 No Change Orders · Free Estimates
Sweep & inspectionSweep & inspection
Caps & crownsCaps & crowns
Flue reliningFlue relining
Masonry repairMasonry repair
Gas fireplace serviceGas fireplace service
Every visit starts with

Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed

Worth knowing

Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.

Get your free estimate

Chimney Company in Long Beach, CA

Chimney repair in Long Beach is rarely about creosote. The marine layer, the salt-laden breeze off the Pacific, and a housing stock full of 1920s-1950s stucco chimneys mean most of what we find is moisture-driven deterioration: rusted dampers, corroded caps, spalling brick, and failing mortar crowns. Santa Ana Chimney Sweep has served Long Beach since 2016, and our crews work the east side bungalow blocks of 90804, the bluff homes off Ocean Boulevard in 90803, and the downtown lofts in 90801 and 90802. If your chimney has been ignored for a few seasons, call (855) 341-9658 and we’ll tell you what’s actually going on up there.

Call (855) 341-9658

Why Long Beach Homes Are Different

Long Beach sits inside a marine influence zone that inland cities like Lakewood or Signal Hill simply don’t share. The onshore flow off the Pacific pushes cool, damp, salt-threaded air over the city most evenings and mornings, sometimes for weeks on end. For a chimney, that means every steel component is fighting corrosion. We routinely replace damper assemblies in Long Beach homes that have rusted through after fifteen or twenty years, not because they were bad parts, but because the environment never lets them dry out. The same applies to chimney caps. A galvanized cap that might last twenty-five years in Carson or West Carson will often show serious rust in half that time a few blocks from the beach.

The housing stock compounds the problem. Much of central and coastal Long Beach was built between the 1920s and 1950s: Spanish Colonial, Craftsman bungalows, and early postwar tract homes. Many still have their original clay-tile flue liners, and a meaningful share of those liners are undersized by modern standards or were installed without a proper crown detail above them. Stucco-clad masonry chimneys are common, and stucco does a poor job shedding water when the crown cap is cracked. Add the occasional dry Santa Ana wind event that stirs up fine grit and drives it into every opening, and you have a city where a simple chimney inspection often turns up three or four separate moisture-related issues at once.

Fireplace use in Long Beach is also light. The climate is mild, most fires are decorative or gas-fed, and wood burning is an occasional treat rather than a nightly routine. That means creosote buildup is modest compared to mountain communities. But it also means chimneys get neglected. A fireplace that hasn’t been lit in two years still has a chimney attached to it, and that chimney is still exposed to the marine air every single day. Neglect plus moisture is the real Long Beach story.

Explore

Styles & brands we work with

Sweep & inspection
Sweep & inspection
Caps & crowns
Caps & crowns
Flue relining
Flue relining
Masonry repair
Masonry repair
Gas fireplace service
Gas fireplace service

Our Main Long Beach Services

Homeowners in Long Beach call us most often for two things: getting their chimney swept and inspected before the brief winter burning season, and clearing dryer vents that have packed with lint in older laundry rooms where vent runs are long and convoluted. Both are fire-safety services, and both are covered by the same crew.

Chimney Sweep in Long Beach

A chimney sweep in Long Beach starts with an inspection of the flue, the cap, the damper, and the crown. In this city, the sweep itself is usually straightforward because creosote volumes are low, but the inspection is where the real value is. We find cracked clay tiles after dry Santa Ana falls, missing spark arrestors on older bungalows, and rusted dampers that won’t close properly. We clean the flue with rotary brushes sized to your liner, not by guesswork, and we document everything with photos so you can see the condition for yourself. Chimney Sweep in Long Beach covers the full process and what to expect.

Chimney Sweep in Long Beach

Dryer Vent Cleaning in Long Beach

Dryer vent cleaning is a fire-safety service, full stop. Long Beach homes built before the 1980s often have dryer vents that run through attics or exterior walls with long horizontal sections, which is exactly where lint accumulates. Lint is fuel, and a dryer pushing hot air through a packed vent is a known ignition scenario. We clean the full run from the dryer to the exterior termination, check the hood and backdraft flap, and confirm airflow with a manometer when needed. Dryer Vent Cleaning in Long Beach explains the process and why Long Beach’s older housing stock makes this service especially relevant.

Dryer Vent Cleaning in Long Beach
Need help today?Fast, friendly service and a no-obligation free estimate.

Call (855) 341-9658

What happens when you call

  1. 1
    A real person answersNo phone trees — you reach a local pro.
  2. 2
    You get an upfront price rangeHonest numbers before anyone is dispatched.
  3. 3
    A background-checked tech heads outLicensed & insured, dispatched right away.
  4. 4
    You approve before work beginsNothing starts until you say go.

Chimney Repair in Long Beach

Chimney repair in Long Beach is driven by salt air, marine damp, and housing stock that predates modern flue standards. Over the years, we’ve pulled rusted damper frames out of 1920s Spanish bungalows in Alamitos Beach, rebuilt crown caps on mid-century tract homes in the 90806 corridor, and installed new stainless dampers on bluff-top homes where the onshore breeze never quits. The work is less about creosote and more about keeping water and salt out of the masonry and the flue. Our repair scope includes cap replacement, liner installation, flashing repair, and crown work, all handled by the same crew that does the sweeping, which means a problem found during an inspection can be quoted and often fixed without hiring anyone else. We also carry the materials to do it right: Chimney Repair is a full trade here, not an upsell.

Chimney Cap Installation

Signs you need it

You see daylight through the flue opening from inside the firebox, or the existing cap is missing, warped, or rusted through.

What it costs in Long Beach

Chimney cap installation in Long Beach typically runs $250 to $550 depending on flue size and whether a custom bracket is required.

How we do it

We measure the flue tile or liner opening, select a stainless cap sized to it, and secure it to the crown with mechanical fasteners and a weatherproof seal.

Chimney Cap Replacement

Signs you need it

The existing cap is rusted, the mesh is punctured, or the cap has lifted off the crown from wind or corrosion.

What it costs in Long Beach

Chimney cap replacement in Long Beach typically costs $200 to $450, with stainless steel caps running at the upper end due to salt-air exposure.

How we do it

We remove the old cap, inspect the crown surface underneath, and install a new stainless cap rated for coastal exposure.

Chimney Liner Installation

Signs you need it

A camera inspection shows cracked clay tiles, gaps between tile sections, or no liner at all in an older masonry chimney.

What it costs in Long Beach

Chimney liner installation in Long Beach typically runs $1,800 to $4,500, depending on flue height, diameter, and whether the home has multiple appliances venting into the same flue.

How we do it

We size the new liner to the appliance and the chimney dimensions, run a pre-insulated stainless liner down the flue, connect it at the appliance, and terminate it with a cap and top plate.

Chimney Flashing Repair

Signs you need it

There’s a water stain on the ceiling near the chimney chase, or the flashing has pulled away from the roofline with visible gaps.

What it costs in Long Beach

Chimney flashing repair in Long Beach typically ranges from $350 to $900, depending on whether we’re resealing existing flashing or cutting and installing new step flashing.

How we do it

We remove the old flashing and sealant, inspect the roof penetration, install new step and counter flashing, and seal the intersection with a marine-grade sealant.

Chimney Crown Repair

Signs you need it

The concrete crown has hairline cracks, spalling edges, or pieces of it have fallen onto the roof or into the yard.

What it costs in Long Beach

Chimney crown repair in Long Beach typically runs $500 to $1,200, depending on whether we’re sealing cracks or rebuilding the crown with a new pour.

How we do it

We clean the crown surface, seal hairline cracks with a flexible crown coat, or form and pour a new crown when the old one is structurally gone.

What Chimney Repair Costs in Long Beach

Item Typical range in Long Beach
Chimney cap replacement $200 – $450
Chimney flashing repair $350 – $900
Chimney crown repair $500 – $1,200
Chimney liner installation $1,800 – $4,500

Salt-air exposure pushes stainless steel components toward the upper end of these ranges in Long Beach, and homes with steep roof pitches or hard-to-reach chimneys cost more because of the access work. We give you a fixed quote before any repair starts, and we’re happy to show you photos of the damage so you can see for yourself what we’re recommending.

How often should a chimney in Long Beach be inspected?

Once a year, even if you rarely burn. The marine air is working on your chimney every day, not just during burning season.

Do I really need a new liner if my chimney has clay tiles that look fine?

Clay tiles can crack or separate in ways that aren’t visible from the top or bottom. A camera inspection shows the full flue wall, and we only recommend a new liner when we can show you the evidence.

Can you fix a rusted damper without replacing the whole chimney?

In most cases, yes. We replace the damper assembly itself, not the chimney, and the masonry around it usually needs no work.

Brands We Service in Long Beach

We name the materials we use, and in Long Beach we’re installing Olympia Chimney caps and dampers, Famco components, Copperfield chase covers, and DuraFlex liners throughout the 90801 to 90804 zip codes. We keep common stainless caps and damper hardware stocked locally, so a typical cap replacement can be completed in a single visit. See our brands for the full range of professional-grade parts we specify and install.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Pricing for Chimney Company in Long Beach, CA

Service Typical range in Long Beach
Chimney sweep (inspection included) $175 – $325
Chimney cap installation $250 – $550
Chimney cap replacement $200 – $450
Chimney liner installation $1,800 – $4,500
Chimney flashing repair $350 – $900
Chimney crown repair $500 – $1,200
Dryer vent cleaning $150 – $275

Prices in Long Beach get pushed upward by a few things: salt-air corrosion that forces stainless steel over painted steel, roof access on steeper bluff-top lots, and older chimneys that need custom-fabricated caps or chase covers rather than off-the-shelf sizes. Whatever the scope, we quote a flat price before the work begins, and we document what we found so you never agree to a repair on faith.

Neighborhoods We Serve in Long Beach

We work throughout Long Beach, from the downtown condos and apartment conversions of 90801 and 90802 to the bluff homes and Spanish-era neighborhoods of 90803 and the bungalow blocks of 90804. Our crews are in the city most weeks, and we schedule to keep drive time down by grouping nearby stops.

  • Alamitos Beach and the 90803 bluff corridor
  • Downtown Long Beach and the 90801/90802 building stock
  • The bungalows and postwar homes of 90804
  • The central 90806 and 90807 residential corridors
  • Naples, Belmont Shore, and the Peninsula

Service Area – Cities Near Long Beach

We also serve the cities that share Long Beach’s coastal conditions and building styles. Homeowners in Signal Hill, CA call us for cap and damper corrosion on homes exposed to the same marine air. In Lakewood, CA and Carson, CA, the housing stock is often the same early-postwar construction we see across central Long Beach. And in West Carson, CA, dryer vent runs and chimney geometry mirror Long Beach closely. Same crew, same flat-price policy, same service area coverage.

Serving Long Beach, CA — Our Local Coverage Area

We’re based in the Long Beach area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.

FAQs About Chimney Company in Long Beach

Ready to get started? Free estimates · Photo-documented response in Long Beach
Call (855) 341-9658

What happens when you call

  1. 1
    A real person answersNo phone trees — talk to a local chimney cleaning pro.
  2. 2
    You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
  3. 3
    We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
  4. 4
    You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.

What Long Beach Customers Say

★★★★★ 4.9 from 11+ reviews

"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."

— Angela Wong

"Something came loose about a month after the work. Called them, and they were back out the next day and fixed it at no charge. Didn't argue, didn't try to bill me for the trip."

— Adam Delaney

"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."

— Marcus Hampton

How It Works in Long Beach

Getting your chimney cleaning handled is simple and fast.

1

Call or Request a Free Estimate

Tell us about your chimney cleaning needs and we provide an upfront, transparent quote — no obligation, no hidden fees.

2

Licensed Technician Dispatched

A background-checked, certified technician arrives in Long Beach — typically within 30–60 minutes, with parts stocked on the truck.

3

Problem Solved, Guaranteed

We complete the job to your full satisfaction, backed by our warranty and 100% satisfaction guarantee.

Request a Free Estimate

Tell us what's going on in Long Beach — we'll get back to you fast. No obligation.

By submitting this form, you agree to the terms of our Privacy Policy and agree to be contacted by call, text, or email regarding your project, including by the service partners who may complete the work.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch
Areas We Serve
Call Now - 24/7 Dispatch