Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Beverly Hills, CA
Chimney repair in Beverly Hills is rarely a routine job. The housing stock spans 1920s Spanish Colonial estates with original clay-tile flues, hillside mid-centuries with metal inserts, and newer tear-down rebuilds, often behind gates and managed by estate staff. The dry, Santa Ana-driven climate bakes creosote hard and leaves unused flues packed with pest debris, while steep tile and slate rooflines make access slow. Santa Ana Chimney Sweep has served Beverly Hills since 2016, handling the full span of repair work, from cracked crowns to full relining. Call (855) 341-9658 to get a technician out.
Why Beverly Hills Homes Are Different
Most fireplaces in Beverly Hills are ambiance, not heat. They burn a few evenings a year, if that, and sit idle through long dry summers. That changes the work. Creosote does not just build up; it glazes onto aging clay tiles and hardens into a coating that resists a standard brush. Soot and debris from overhanging eucalyptus and ficus settle into flues and pack down over months of disuse. Then there are the pests: pigeon and squirrel nesting is common in flues that never see a draft, and the debris is often the first thing we haul out before any inspection starts.
The architecture adds another layer. Beverly Hills is dense with 1920s through 1950s estates built with original brick and clay-tile masonry fireplaces. Many flues are unlined or have clay liners that crack and spall after decades of thermal stress, even with light use. Hillside mid-centuries often carry prefab or metal flue inserts that corrode in ways masonry chimneys do not. And the rooflines – steep clay tile, slate, complex pitch changes – mean repair access is slower and more deliberate than a simple ranch-house roof elsewhere in Los Angeles County.
Access is its own tradecraft here. A significant share of Beverly Hills homes sit behind gates, operate under HOA rules, or are managed by estate managers and property firms. Scheduling often runs through a third party, and the job itself requires discretion, clean work sites, and paperwork that satisfies a management office. We are used to all three. Pre-sale inspections are a common trigger: a realtor or estate manager calls because a chimney has not been touched in years and the transaction cannot close without a condition report. What we find is often a flue full of nesting material, a disintegrating cap, and glazed creosote the owner swore had never been used.
Styles & brands we work with
Our Main Beverly Hills Services
Most Beverly Hills calls come in for one of two things: a deep chimney sweep on a fireplace that has not been serviced in years, or a dryer vent cleaning bundled into the same visit. Both are fire-safety services.
Chimney Sweep in Beverly Hills
A sweep in Beverly Hills usually starts with debris removal: nesting, leaves, and eucalyptus litter pulled from the flue before the brushwork begins. The creosote here tends to be baked and glazed from dry heat, so we use the appropriate tools to break it down without damaging older clay tile. Every sweep includes a visual condition check of the cap, crown, and liner, because unused chimneys hide problems that only show up under inspection. For the full scope, see Chimney Sweep in Beverly Hills.
Dryer Vent Cleaning in Beverly Hills
Dryer vents are a leading home fire cause, and in Beverly Hills many vent runs are long, routed through walls or crawl spaces, and rarely opened. Lint packs tight in the warm, dry air and becomes fuel waiting for heat. We clean the full run from the dryer connection to the exterior termination, verify airflow, and check the termination flap for blockages. This can be bundled with a chimney appointment or booked alone. Details at Dryer Vent Cleaning in Beverly Hills.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Beverly Hills
Chimney repair in Beverly Hills is defined by the age of the housing and the long idle periods between fires. Chimney Repair here usually means addressing clay liners cracked and spalled from decades of thermal cycling, crowns broken open by rare winter rains, and caps rusted through or torn off by Santa Ana winds. Homes from the 1920s through the 1950s dominate the 90210, 90212, and 90213 ZIP codes, and a lot of their original masonry is still in place, which means the flue condition, not the fireplace facade, is where the work concentrates.
We repair, not just inspect. When a camera inspection shows a compromised flue, the same crew can address it, whether that means a new cap, a rebuilt crown, or a full relining.
Chimney Cap Installation
Signs you need it
Missing cap, rust-through, or visible debris and nesting inside the flue opening.
What it costs in Beverly Hills
Cap installation typically runs $195 to $525 depending on the flue size and cap material specified.
How we do it
We verify the flue dimensions, set the cap with a mechanical fastener, and seal the edges against water intrusion.
Chimney Cap Replacement
Signs you need it
Rust, dents, lifted seams, or a cap that no longer blocks rain and embers.
What it costs in Beverly Hills
Replacement runs $200 to $550 in Beverly Hills, with the higher end covering stainless caps on larger or custom flues.
How we do it
We remove the old cap, clean the flue lip, and install a correctly sized replacement, often from Olympia Chimney or Famco, and confirm the spark-arrestor mesh is intact.
Chimney Crown Repair
Signs you need it
Cracks in the concrete crown, standing water on top of the chimney, or water staining on the ceiling near the chase.
What it costs in Beverly Hills
Crown repair is typically $325 to $800 in Beverly Hills, with more for crowns requiring a full recast.
How we do it
We clean the crack, fill and seal it, or build a new crown with proper slope and a drip edge so water moves off instead of pooling.
Chimney Flashing Repair
Signs you need it
Water staining around the chimney at the roofline, damp attic insulation near the chase, or visible gaps in the flashing.
What it costs in Beverly Hills
Flashing repair runs $350 to $850, and higher when steep clay-tile or slate roof access adds labor.
How we do it
We remove the old flashing, reset new step and counter-flashing, and seal the junction with a high-temperature, weather-rated sealant.
What Chimney Repair Costs in Beverly Hills
| Item | Typical range in Beverly Hills |
|---|---|
| Chimney cap installation | $195 – $525 |
| Chimney cap replacement | $200 – $550 |
| Chimney crown repair | $325 – $800 |
| Chimney flashing repair | $350 – $850 |
Can you repair a chimney at a Beverly Hills home with steep roof access?
Yes. We work on steep clay-tile and slate rooflines throughout Beverly Hills. Our technicians set up for safe access before touching the chimney, which adds some labor to the quote but keeps the work controlled.
Do I need a liner replacement or can the existing one be saved?
We decide only after a camera inspection shows the flue condition. Clay liners with minor cracking can sometimes be resurfaced with HeatShield, but heavily spalled or separated sections usually require a DuraFlex reline. You will see the footage before any recommendation.
Brands We Service in Beverly Hills
We specify and service professional-grade parts from Olympia Chimney, Famco, Copperfield, and DuraFlex. We stock common cap and crown materials locally and can source the rest quickly. Details are on our brands page.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Beverly Hills, CA
| Service | Typical range in Beverly Hills |
|---|---|
| Chimney cap installation | $195 – $525 |
| Chimney cap replacement | $200 – $550 |
| Chimney crown repair | $325 – $800 |
| Chimney flashing repair | $350 – $850 |
| Chimney liner installation | $2,500 – $6,500 |
| Chimney sweep | $295 – $595 |
| Dryer vent cleaning | $150 – $350 |
What pushes a quote higher in Beverly Hills is almost always access: steep rooflines, gated or HOA-restricted properties, and flues that have not been opened in years. The price we confirm upfront is the price you pay. No open-ended work orders, no surprise add-ons after we start.
Neighborhoods We Serve in Beverly Hills
We work across Beverly Hills and the surrounding ZIP codes, from the estates north of Sunset to the neighborhoods south of Wilshire and into the hills. Our technicians know the access realities of gated properties and the older masonry common to the area’s original housing stock. Response is typically same-week for most chimney repair and sweep calls.
- The Flats
- Trousdale Estates
- Beverly Hills Gateway
- Beverlywood-adjacent Beverly Hills
- Benedict Canyon
Service Area – Cities Near Beverly Hills
We also cover the surrounding West Los Angeles corridor. Homeowners in Century City, CA, West Hollywood, CA, Culver City, CA, and Hollywood, CA call us for the same chimney repair, sweeps, and dryer vent work, and the housing stock in those areas shares many of the same age and access issues we see in Beverly Hills.
Serving Beverly Hills, CA — Our Local Coverage Area
We’re based in the Beverly Hills area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Beverly Hills
Most Beverly Hills appointments are scheduled within the same week, often sooner for pre-sale inspections where a realtor or estate manager has flagged a pending close. Call (855) 341-9658 and we will give you an actual date, not a window.
That depends on the community. Some Beverly Hills HOAs require notice or approval before roof-level or exterior work, and many gated properties need gate access arranged in advance. We are experienced working through management offices and will coordinate the scheduling once you confirm any required approvals.
Yes. A significant portion of our Beverly Hills work comes through estate managers, realtors, and property firms. We provide the written condition findings and photos they need, and we work discreetly, on schedule, with minimal disruption to the property.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Beverly Hills Customers Say
"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Scott Meyer"New to Santa Ana and had no idea who to call. A neighbor gave me their number and I've since passed it on to two other people on the street."
— Luis Guzman"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Dev Rao